Polaris 480PRO Bedienungsanleitung Seite 8

Troubleshooting
If the Polaris cleaner regularly displays
the following actions, adjustments may be
necessary to restore performance. Refer to
exploded parts diagram for part numbers
indicated in parentheses.
Action:
Solution:
Action:
Solution:
Action:
Solution:
Hangs up on steps or other
obstacles longer than 3
minutes.
1. Check the wheel RPM.
2. Verify the back-up valve
(#45) is cycling.
3. Adjust the thrust jet.
4. Remove unnecessary pool
hardware or install a Ladder
Guard Kit (order part #G21
from a Polaris dealer).
Polaris is sluggish, running
with less power than normal.
1. Check the filter screen (#40)
in the in-line filter assembly
(#39) and clean if necessary.
2. Clean the skimmer basket,
pump basket, and pool filter.
3. Check the hoses,
connections, and swivels
(#42) for leaks that could
cause loss of water pressure.
4. Check the wheel RPM.
Polaris flies around the pool
and/or does not make contact
with the bottom of the pool.
1. Check the wheel RPM. If
more than 36 RPM, unscrew
the pressure relief valve
(#34) to decrease water flow
to cleaner.
2. Install the blue restrictor
disc in the UWF to decrease
water flow. Or, install the red
restrictor disc to decrease
the water flow even more.
3. Verify the back-up valve
(#45) is cycling. Hold the
www.polarispool.com
valve out of the water and
watch the jet. It should come
on and go off.
Action: Polaris doesn't back up.
Solution: 1. Verify the back-up valve
(#45) is cycling.
2. Check the wheel RPM.
3. If the filter bag (#1 or #2) is
full, empty or replace it.
4. Make sure feed hose
is floating.
Action: Polaris only turns in one
direction.
Solution: 1. Adjust the thrust jet.
2. Make sure feed hose
is floating.
Action: Feed hose becomes tangled.
Solution: 1. Remeasure the hose to
verify that it is adjusted to
the proper length for the
pool shape.
2. With the Polaris operating,
check that the swivels (#42)
in the hose and the hose
connections turn freely.
3. Make sure the feed hose is
floating.
4. With the Polaris operating,
hold the cleaner under water
and verify that all three
wheels are turning together.
Action: Sweep hose is sucked into the
vacuum tube.
Solution: 1. Make sure the opening at
the end of the sweep hose
(#25) is not blocked by the
sweep hose scrubber (#22).
Replace scrubber if it is
worn or missing.
2. Adjust the sweep hose (#25)
to a gentle sweeping motion.