In-Line Filter - Polaris 480PRO Bedienungsanleitung

Attaching the Disposable Filter Bag
1. Depress the prongs to release the
all-purpose bag from the cleaner.
2. Align the bag clip assembly over the
vacuum tube and snap it onto the
cleaner.
3. Push tabs of bag clip assembly to the
open position.
4. Fit cuff of disposable bag over opening.
Bag seam should face the back of the
cleaner and hole in filter bag cuff
should engage with alignment pin.
Close bag clip assembly to lock
in place.
5. To replace disposable bag, release the
tabs on the bag clip assembly,
disengage the alignment pin and install
new bag.

In-Line Filter

The in-line filter contains a filter screen to
keep debris that is not caught by the pool
filtration system out of the Polaris.
To clean this screen, pull it out of the
in-line filter, rinse it and press it firmly back
into place.
Backwashing the Pool Filter
Always disconnect the Polaris from the pool wall before cleaning or backwashing the pool
filter. After cleaning or backwashing, let the filtration system run for at least five minutes to
flush out the return lines before re-connecting the Polaris.
Storage and Winterizing
Never store the Polaris in direct sunlight. When storing for the winter, drain out all the water
(freeze damage is not covered under the warranty). Remove the UWF from the pool wall
using the UWF Removal Tool (part #10-102-00) included with the cleaner.
Disposable Bag
Alignment Hole
Back of Cleaner
Open
www.polarispool.com
Bag Clip
in Open
Position
Alignment Pin
In-Line Filter