Compliance Statement And Information - Tascam VL-S3BT Bedienungsanleitung

Owner's Manual
Compliance Statement and
information
This product has the function of broadband trans-
mitter using 2.4 GHz Band.
Use frequency range: 2400 MHz - 2480 MHz
Maximum output power: Bluetooth® Class2 (less
than 2.5 mW)
CAUTION
Use only in the country where you purchased the
product.
• Authorization of wireless devices are different in
countries or regions.
• Depending on the country, restrictions on the
use of Bluetooth wireless technology might exist.
CAUTION
Changes or modifications to this equipment not
expressly approved by TEAC CORPORATION for
compliance could void the user's authority to operate
this equipment.
Radiation Exposure requirements
This equipment meets the regulation, which is recog-
nized internationally, for the case of human exposure
to radio waves generated by the transmitter.
8 Model for U.S.A
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Labeling of authorization
FCC ID: XEG-VLS3BT
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful inter-
ference in a residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance
with the instruction manual, may cause harmful inter-
ference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct
the interference by one or more of the following
measures.
a) Reorient or relocate the receiving antenna.
b) Increase the separation between the equipment
and receiver.
c) Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
d) Consult the dealer or an experienced radio/TV
technician for help.
FCC Radiation Exposure Statement
This device complies with FCC radiation exposure
limits set forth for an uncontrolled environment and
it also complies with Part 15 of the FCC RF Rules.
This equipment must be installed and operated
in accordance with provided instructions and the
antenna(s) used for this transmitter must be installed
to provide a separation distance of at least 20 cm
from all persons and must not be co-located or
operating in conjunction with any other antenna or
transmitter.
End-users and installers must be provided with
antenna installation instructions and consider
removing the no-collocation statement.
8 Model for Canada
Compliance of radio transmitter
This device complies with Industry Canada's license-
exempt RSSs. Operation is subject to the following
two conditions:
(a) This device may not cause interference; and
(b) This device must accept any interference,
including interference that may cause undesired
operation of the device.
Labeling of authorization
IC: 1559C-VLS3BT
Compliance of interference
This Class B digital apparatus complies with Canadian
ICES-003.
Labeling of compliance
CAN ICES-3(B)/NMB-3(B)
3
TASCAM VL-S3BT