Installation And Assembly; Packing, Transport And Storage - Kripsol OK Betriebs- Und Wartungsanweisung

Bomba OK:Bomba OK.qxd 27/01/2010 15:37 Página 12
3.7
Electricity conductors, or parts which
could carry current, will be suitably
insulated. Other metal parts of the
equipment will be correctly earthed.
3.8
Spare parts that may be necessary will
be originals from the manufacturer or
those recommended by the manufacturer.
The use of others, or originals rectified
by others, are not permitted and release
the manufactured of distributor from all
liability.
4. PACKING, TRANSPORT AND
STORAGE
4.1
ATTENTION
The manufactured supplies the equipment
protected in suitable packaging, so that
it is not damaged during transport or
storage thus preventing its correct
installation and/or functioning.
4.2
ATTENTION
The user, upon receipt of the equipment, will
immediately check the following points:
- Condition of the outside packaging, if
this shows sings of serious deterioration,
he shall formally advise the person
delivering the equipment.
- He shall also check the condition of
the contents; should this show defects
which would
correct functioning, he shall also formally
presumably prevent
notify the supplier within a period not
exceeding 8 days from the date of delivey.
4.3
ATTENTION
Storage conditions must ensure the
optimum preservation of the equipment.
Due to its particular relevance, we must
stress that very damp atmospheres or
others where brusque changes in
temperatures (which cause condensation)
must be avoided

5. INSTALLATION AND ASSEMBLY

5.1. LOCATION.
ATTENTION
The place where the electropump is to be
located must be dry. In all events, there
must be a drain in the floor as a prevention
against flooding. If the pump is to be
located in a damp place, a ventilation
system must be provided in order to
prevent the formation of condensation.
In the case of very confined areas, cold
air can reach a low temperature which
requires a ventilation system whereby
the atmospheric temperature does not
exceed 50ºC.
It is important for there to be sufficient
space to permit the motor block to be
dismounted horizontally and the air
filter vertically (see minimum space
diagram in fig. 1, page. 37).
5.2. POSITIONING / INSTALLATION.
ATTENTION
The equipment or set of motor pump,
filter and selection valve, will be installed
near the swimming pool at a distance of
12