General Instructions In Relation To User Safety - Kripsol OK Betriebs- Und Wartungsanweisung

Bomba OK:Bomba OK.qxd 27/01/2010 15:37 Página 11
2.2 NAMEPLATE RATINGS (EEC
89/392 P.1.7.4.A).
The information given on the nameplate
or other instructions affixed by the
manufacturer to the unit, must be
strictly complied with. The content of
these plates can usually be found in this
Handbook (Chapter 1.2.).
2.3 LIABILITY.
Failure to comply with the instructions
given by the manufacturer in this
Handbook, in relation to the choice,
handling, installation, starting and
maintenance of the unit, shall release
the manufacturer or distributor from all
liability in respect of accidents suffered
by persons or damages caused to other
installations and, in addition, shall entail
forfait of the warranty.
2.4 STANDARDS.
Our swimming pool electropumps are
manufactured in accordance with the
necessary requeriments for safety and
health set
Directives 89/392/EEC, 91/368/EEC
(assimilated into Spanish Law by Royal
Decrees 1435/1992 and 93/44/EEC).
3. GENERAL INSTRUCTIONS IN
RELATION TO USER SAFETY
3.1
Safety during operation of the machinery
supplied can only be guaranteed if it is used
in accordance with the diagrams shown on
page 37 "ILLUSTRATIONS". It must never
exceed the working conditions and limits
given in this Handbook (Chapter 1.2 Technical
Characteristics).Compliance with the
provisions of Safety Standards in force
in each country is mandatory.
forth in Community
3.2
Please ensure that the equipment
selected is adequate for the use for
which it is intended and that its
condition, installation, starting and
subsequent use are correct. See
chapter 1 (Technical Characteristics).
3.3
Installation, repair and maintenance
operations will be carried out in all
cases with the equipment disconnected
from the mains.
3.4
While the equipment is functioning, it
cannot be moved or repositioned.
These operations will be carried out at
all times with the machine disconnected.
3.5
Pressing of the electrical on/off or
safety elements will not be performed
where there is damp, and special care
must be taken for user´s hands to be dry,
and also with footwear and surfaces
with which the user is in contact.
3.6
Those elements of the equipment wich,
when functioning, are in movement or
which could reach dangerous temperatures,
will be protected with cages or casing
which will prevent accidental contact
with the same.
11