English - Kripsol OK Betriebs- Und Wartungsanweisung

Bomba OK:Bomba OK.qxd 27/01/2010 15:37 Página 10
1. DESCRIPTION
1.1 These electropumps have been
designed to recirculate lightly treated
water in swimming pools and spas, both
private and public.
1.2 TECHNICAL CHARACTERISTICS.
Motor:
Power rating: See nameplate ratings on
Insulation : Class E.
Operation : Continuous.
Protection : IP 54.
Current : Monophase and triphase
(see nameplate ratings).
Consumption : See nameplate ratings.
Frecuency : See nameplate ratings.
R.P.M. : See nameplate ratings.
Shaft : Stainless steel.
Bearing : Armoured ball bearing.
Atmospheric temperature:Maximum 50ºC.
Pump:
Water temperature : Maximum 50ºC.
Maximum pressure: 2 bar.
Impeller model
Type of seal
Impeller & diffuser casing : Type OK, synthetic
Pump casing
Filter cover
Basket
Aspiration diameter :11/2" gas Screw (type OK).
Impelling diameter :11/2" gas Screw (type OK).

ENGLISH

electropump.
: Closed.
:Mechanical retainer.
material (PPO).
: Type OK, synthetic
material (PP).
: Type OK, synthetic
material (SAM).
: Synthetic material(PP)
in type OK.
2. GENERAL
2.0 INTRODUCTION
This Handbook contains the necessary
instructions for installation, use and
maintenance of the swimming pool
electropump. In order to obtain the
maximum yield
manufacturer in the Description of
Characteristics, it is necessary to fulfil
and follow correctly all the recommen-
dations given in this Handbook.
This will allow operation with a safe and
long-lasting piece of equipment.
The equipment supplier will furnish the
user with complementary information, if
required.
2.1 SAFETY SIGNS USED IN THE
HANDBOOK.
All instructions referring to possible
risks to persons are highlighted by the
following symbols:
Danger in
general
Standard DIN
4844-W9
Other instructions in relation to the
functioning of the equipment with which
non-compliance could cause physical
damages are highlighted with the
warning:
ATTENTION
10
shown by the
Danger of
electrocution
Standard DIN
4844-W8