Surface Mounting - Cable Invisible; Surface Mounting - Cable Visible; Electrical Installation - Cedes TPS-Serie Montage- Und Bedienungsanleitung

TPS
5.2.

Surface mounting - cable invisible

Figure 8: Backside view of a surface-mounted TPS
1. Drill holes
2. Lead connector through the hole
3. Mount sensor with screws (recommended
screws are flat headed torx)
4. Connect wires (see Figure 10)
5. Set trigger level (see Figure 4)
6. Clip window to sensor
5.3.

Surface mounting - cable visible

Figure 9: Backside view of a surface-mounted TPS
1. Drill holes
2. Cut slots from sensor on the back side.
3. Lead connector through the slots
4. Mount sensor with screws (recommended
screws are flat headed torx)
5. Connect wires (see Figure 10)
6. Set trigger level (see Figure 4)
7. Clip window to sensor
6
(All dimensions in mm)
(All dimensions in mm)
www.cedes.com
Installation and operation manual
5.4.

Electrical installation

Standard M8 male connector
Pin allocation based on industry standard:
Pin 1: +U
Pin 2: PNP or NPN Output B (black)
Pin 3: GND (blue)
Pin 4: PNP or NPN Output A or test
input (white)
Top view of the connector (view to the pins)
Figure 10: Connecting diagram of the connector
1. Connect the sensor to connecting cable
2. Connect the wires in the control device
according to pin allocation
(brown)
sp
© CEDES/November 2012