Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
OFFSET
is the data which is used to align the temperature shown on the display with the actual internal temperature.
Adjustment for each offset can vary from -8 / +8.
After a few hours of refrigeration system operation, insert a digital thermometer (not included) inside the
compartment in the position where you wish to have a more precise temperature and check that the tem-
perature indicated on the display coincides with the temperature read on the digital thermometer. If it does
not coincide, change the Offset related to the temperature you wish to reach inside the compartment until
the temperature read on the display coincides with the temperature indicated on the digital thermometer.
Offset
1
2
3
REPLENISHMENT
Do not place hot food in the refrigerator. Arrange the products so that they do not knock or damage each
other whilst the vehicle is moving. When in use, ensure that the cover is always correctly closed and only
open where necessary. When not in use, keep the cover open to ventilate the inside.
DEFROSTING
When the ice layer is greater than 4 mm thick, the refrigerator must be defrosted. Switch off the refrigerator
whilst doing this. Do not use sharp objects to remove layers of frost or ice. Wait until everything has com-
pletely melted, dry the refrigerator and only switch it back on upon finishing the aforementioned operation.
LOW VOLTAGE PROTECTION
In order to prevent excessive battery depletion, a protection device shuts off the compressor in case of
insufficient voltage and turns it back on when the voltage in the system increases after the batteries have
been charged.
Battery
level
Low
Medium
High
20
Battery Protection
Digital
Cut-Out
Display
Comp. off
9.6
11.1
11.8
Temperature Interval
T ≥ -6°C
-12°C ≤ T ≤ -7°C
T ≤ -13°C
12Vdc
Cut-In
Comp. on
10.6
12.1
12.8
TB16AM
24Vdc
Cut-Out
Cut-In
Comp. off
Comp. on
21.3
22.7
22.3
23.7
24.3
25.7
TB16AM_29-03-2018
Werbung
Inhaltsverzeichnis
