Virax V 150+ Bedienungsanleitung Seite 20

Usage precautions: refer to the Specific safety instructions section
Drilling phase: refer to the core drill's manual
Tilted drilling
Water drilling
When using the core bit with water cooling, we recommend that you use a
water collector. This is fixed to the base screw and guarantees clean
drilling.
III - Drilling
1. Remove the nut from the plate that holds the column
at 90°.
2. Loosen the 2 screws between the support stand and
the column and select the angle you want.
3. Tighten the 2 screws again.
For the support stand 050121 only:
4.
The Phillips screw at the back of the column must
also be loosened.
CAUTION during tilted drilling, the drilling must be
started very slowly.
20
-EN-