Fitting The Cim 060 Into A Cu 362; Connecting Grundfos Go; Via The Connection Button - Grundfos CIM 060 Anleitung

4.2 Fitting the CIM 060 into a CU 362

• Remove the back cover of the CU 362.
• Click the CIM 060 on top of the main board, in the
back of the CU 362. See fig. 4.
• Fit the screw in the bottom mounting hole.
• Use cutting pliers to cut out the back cover of the
CU 362, around the external antenna connector.
See fig. 1, pos. 6.
See also section installation and operating
instructions of the CU 362.
Fig. 4 Fitting the CIM 060 in the CU 362
If the product is to be connected to a GSM network,
connect the CU 362 to a CIU 250 unit in this way:
• Install a CIM 040 in the CIU 250 box next to the
CIM 250.
• Connect the CIM 040 to the TTL service port of
CU 362 via the TTL cable provided with the
CIM 040. See fig. 5.
CIU 250
CIM CIM
250 040
Fig. 5 CIM 060 in a CU 362 connected to a
GSM network
CU 362
CIM
060
TTL cable

5. Connecting Grundfos GO

See also installation and operating instructions of the
Grundfos GO.

5.1 Via the connection button

1. Select [Connect] in the main menu, under
[Remote]. See fig. 6, pos. 1.
2. Press [List].
3. Select the product hosting the CIM 060. It may be
necessary to press the wink button to identify the
product. See section
4. Press the connection button on the module
(within 30 seconds). The LED is now
permanently green and the CIM 060 is connected
to Grundfos GO.
Alternatively, if the product is the only one in range,
press [Connect] instead of [List], and skip step 3.
1
2
Fig. 6 Main menu in Grundfos GO
3.3 LED.
7