Maintenance; Waste Disposal - Silca POKER Handbuch

Contents of packing
Check that the packing box contains:
1 key-cutting machine enclosed in the protective shells
1 supply connecting wire
1 tool kit
1 set of documents, including:
Operating Manual
It is advisable to keep the cardboard box in good condition, as it may be used again (e.g. removals, dispatch to the
manufacturers for repairs or servicing).
Handling the machine
When the key-cutting machine has been unpacked, place it directly on its workbench. This operation can be carried out
by one or more persons firmly holding the base, and no other part, to lift and carry the machine.

MAINTENANCE

Although our key-cutting machines do not require special maintenance, it is advisable to check and, if necessary, replace
the parts subject to wear, such as: cutting tool, tracer point, transmission belt and brush, if applicable.
Replacement: the operations are simple and can be carried out by the operator. The removable parts are so designed
as to exclude the possibility of their being re-assembled or installed wrongly or dangerously.
Cleaning: keep the carriage and clamps free of chippings from the cutting operations by cleaning with a dry brush.
WARNING! DO NOT USE COMPRESSED AIR.
Before starting any type of maintenance read the instructions below:
never carry out maintenance or servicing with the machine in motion
always remove the mains plug
use original spare parts

WASTE DISPOSAL

EU regulations establish special arrangements for the disposal of waste (*).
Packing
Our key-cutting machines are consigned in a cardboard packing box which can be re-used if undamaged.
When it is to be thrown away it is classified as solid urban waste (SUW) and should be placed in the special paper
collecting bins.
The protective shell containing the machine is in polymer, classified as SUW, and can therefore be placed in an ordinary
waste bin.
Cutting machine
Our key-cutting machines are designed for many years of operation and re-cyclable materials are used in their
manufacture. Re-cycling is a recommended ecological practice.
Waste deriving from cutting operations
Although residue coming from the key-cutting operations is classified as special waste, it is included in solid urban waste
(SUW) as metal wool.
Such waste is sorted according to its classification under current Italian and EU law and consigned to the proper
disposal units.
Cases where waste can be considered contaminated or containing toxic/harmful substances sufficient to transform it
from SUW to toxic/harmful waste, are listed in the enclosures to current Italian and EU waste disposal regulations.
(*)
"Waste" is any substance or object deriving from human activity or natual cycles, thrown away or to be thrown away.
ASSISTANCE
Silca provides full assistance to purchasers of its key-cutting machines. To ensure complete safety for the operator and
the machine, any job not specified in the manual should be carried out by the manufacturer or in the special service
centres recommended by Silca.
Below is a list of Silca specialised Service Centres all over the world.
How to request service
The guarantee attached to our key-cutting machines ensures free repairs or replacements of faulty parts within six
months of purchase.
All other service calls must be arranged by the customer with Silca or with a Service Centre.
Silce is always at your disposal for technical information or clarification.
General Instructions Spare parts list
Copyright Silca 1994
Guarantee form