General Instructions; Safety Regulations - Silca POKER Handbuch

®
Our key-cutting machines are designed according to the specifications of the Machine Directives. From the
design stage risks for the operator have been eliminated in all areas: transport, key-cutting, regulation and
maintenance.
Other risks have been eliminated almost completely by the use of protective devices for the operator.
The protective devices used are designed not to provoke further risks and, above all, they cannot be ignored
unless deliberately cut out. They do not hinder visibility of the work area.
The materials used in the manufacture of this machine and employed during its use are not dangerous and all
comply with the directives.
To operate under conditions of maximum safety do not use the key-cutting machine without reading
and understanding clearly the contents of the Operating Manual and this leaflet; only in this way can
you become familiar with the machine, its functions, limitations and possible dangers.
Keep this leaflet in a safe place and make sure that every person who has to use the key-cutting
machine reads it carefully.

SAFETY REGULATIONS:

1) The use of protective goggles is compulsory during key-cutting operations; badly installed
keys or loose chippings could fly out and damage to the eyes.
2) Always make sure that the protective shields are in place on the machine.
3) Check the electrical wiring periodically; if the wires are worn they should be repaired or
replaced.
4) Never work with wet, greasy or oily hands.
5) Disconnect the machine from the mains when it is not in use or in order to carry out
maintenance work (e.g. replacing the cutting tool or brush, if applicable).
6) Never tug at the electricity supply wire and make sure it does not come into contact with
oil, sharp objects or excessive heat.
Never remove the earth wire from the plug and check regularly that it is properly
connected.
7) If the key-cutting machine is used outdoors, make sure that the extension is provided with
an earth wire.
8) Do not use the machine in dangerous places (damp or wet) and ensure that it is well
illuminated during operation.
9) Never attempt to remove the key blank or original key from the clamps when the cutting
tool is in motion.
10) Do not use compressed air to remove cutting dust and chippings.
11) Keep the work area clean and free of work tools: untidiness can cause accidents.
12) Do not allow visitors, especially children, to stand near the machine or its wiring; insist that
they keep a safe distance.
13) Do not use the machine for purposes different from those described in the Operating
Manual.
14) Never strain the machine for any reason; it will work better and more safely.
15) Wear suitable clothing when using the key-cutting machine, avoiding voluminous garments, ties or
jewellery which could be caught up in the moving parts.
16) Always secure the keys in the clamps properly. Never hold the head of the key during cutting. If the key
will not lock securely into the clamp, do not attempt to cut it.
17) Ensure that the cutting tool is always sharp; a worn, blunt blade is not only inefficient but also
dangerous.
18) Always pay careful attention to the work you are doing and do not use the machine if you are tired.
19) Do not operate the machine under the influence of alcohol, drugs or medicines.
20) Do not use the key-cutting machine if the ON/OFF switch is not working properly.
21) Always keep these instructions to hand.
POKER

GENERAL INSTRUCTIONS

IMPORTANT
Copyright Silca 1994
GB