Bosch CRS 845H Einbauanleitung Seite 37

4.2.6 Assembly of rear panel
1. Affix the handles to the two rear panels.
2. Affix the rear panels to the rear splash guard housing.
Fig. 22: Preparation and assembly of rear panels
Robert Bosch GmbH
Installation | CRS 845H | 37
4.3 Installation of overflow control valve
i
All items required for assembly are contained in the
parts kit 1 687 417 087.
4.3.1 Set bore for overflow control valve
i
As of PD 06-2002, this hole is already integrated in
the test bench frame. In this case, you can skip this
section.
1. Remove side covers from the test bench.
2. Cover test-oil tank carefully. This is to ensure that no
metal filings can fall into the tank.
3. Mark the bore positions on the test bench using the
following drawing.
Fig. 23: Location for affixing the type label
Measuring table:
Unit h1 b1
mm 535 39
inch 20,87 1,52
!
Make sure that when you break through with a twist
drill or center bit that the hydraulic hoses are not
damaged.
4. Use a hand-held power drill and suitable drill bit to
bore the d1 and d2 holes in the test bench frame.
5. Deburr the bores.
6. Carefully remove any metal filings left over from the
test bench.
en
d2
d1
d2
b1 b1
h1
b2 d1 d2
19 20 7
0,74 0,78 0,27
|
1 689 978 535 2014-10-21