Inhaltsverzeichnis
Werbung
SERVICING & CLEANING
• Cleaning chrome: Do not use abrasive, chlorine or acid-based cleaning products. Clean with soapy
water using a cloth or a sponge.
• Frost protection: Drain the pipes and operate the mixer several times to drain any remaining water.
REMEMBER:
• Our mixers must be installed by professional installers in accordance with current regulations
and recommendations in your country, and the recommendations of the fluid engineer.
• Sizing the pipes correctly will avoid problems of water hammer and loss of pressure/flow rate.
(See the calculation table in the brochure or on line at www.delabie.com).
• Protect the installation with filters, water hammer absorbers or pressure reducers to reduce
the frequency of maintenance.
• Install stopcocks close to the mixer to facilitate maintenance.
• The pipe work, stopcocks, check valves and all sanitary fittings should be checked at least once a
year, and more frequently if necessary.
THE INSTALLER MUST ENSURE:
• THE SEAL AROUND THE RECESSING BOX IS WATERPROOF TO PREVENT ANY INGRESS OF WATER; ANY WATER
ACCIDENTALLY ENTERING THE RECESSING BOX (E.G. CONDENSATION, RUN OFF, LEAKS, ETC.) HAS A DRAINAGE
POINT;
• THE INTEGRITY OF THE SEALS BETWEEN THE WALL PLATE SUPPORT AND THE WALL AT LEAST ONCE A YEAR,
AND MAKE GOOD IF NECESSARY.
If this advice is not followed, water may leak into the wall. DELABIE cannot be held responsible for any
ingress.
IF YOU HAVE ANY QUERIES CALL TECHNICAL SUPPORT ON THE NUMBER BELOW.
For UK market only: Tel. 01491 821 821 email: technical@delabie.co.uk
For all other markets: Tel. +33 3 22 60 22 74 email: sav@delabie.fr
The most recent version of this installation guide is available on: www.delabie.com
After Sales Care and Technical Support:
EN
Werbung
Inhaltsverzeichnis
