Technical Specifications - Vitek VT-1198 ST Betriebsanweisung

ENGLISH
unit. Do not cover the light sensor with foreign
objects.
To turn off the power-saving mode, press and
hold down the button (20) «TEMPERATURE
SELECTION» for more than 5 seconds, and the
power-saving mode indicator (22) goes out.
CLEANING AND CARE
•
Before cleaning, disconnect the unit from the
mains, let it cool down.
•
Remove the lid (11).
• Pour out the remaining water from the ther-
mopot, install the lid (11) back to its place.
• Clean the thermopot's outer surface with a
soft damp cloth and then wipe the unit dry. Do
not use metal brushes, abrasives and solvents
to clean the thermopot.
•
Do not immerse the thermopot, the power
cord and the power plug into water or other
liquids.
• Do not wash the thermopot in a dishwashing
machine.
Stains on the inner surface of the thermopot
The inner metal surface may change its color
under the influence of different water impurities.
•
To remove the stains, wet a cloth with citric
acid or vinegar and wipe the inner surface of
the thermopot flask.
•
To remove the flavour of citric acid or vinegar,
boil water and pour it out. Repeat this proce-
dure several times until the smell and taste
vanish completely.
Descaling
•
Scale, appearing inside the thermopot, influ-
ences the water taste and disturbs the heat
exchange between water and heating ele-
ment, which can lead to overheating and mal-
function.
•
To remove scale, fill the thermopot flask with
a mixture of one part ordinary vinegar and two
parts water up to the maximal water level mark
«FULL» (14). Boil the liquid and leave it in the
unit overnight.
VT-1198.indd 6
•
In the morning pour out the liquid, fill thermo-
pot with clean water up to the maximal mark
«FULL» (14), boil and pour out the water;
if necessary repeat this procedure twice.
• You can use special detergents for electric
kettles to remove scale, strictly following the
instructions on their usage.
•
Clean the thermopot from scale regularly.
STORAGE
•
After using the unit, turn it off and wait until it
cools down.
•
Open the lid (11).
• Drain water from the thermopot, wipe it dry,
install the lid (11) in place and take the ther-
mopot away for storage.
DELIVERY SET
Thermopot – 1 pc.
Power cord – 1 pc.
Instruction manual – 1 pc.

TECHNICAL SPECIFICATIONS

Power supply: 220-240 V ~ 50 Hz
Power consumption: 750 W
Maximum water capacity: 4 l
The manufacturer preserves the right to change
design and specifications of the unit without pre-
liminary notification
Unit operating life is 3 years
Guarantee
Details regarding guarantee conditions can be
obtained from the dealer from whom the appli-
ance was purchased. The bill of sale or receipt
must be produced when making any claim under
the terms of this guarantee.
This product conforms to the EMC-
Requirements as laid down by the Council
Directive 2004/108/ЕС and to the Low
Voltage Regulation (2006/95/ЕС)
6
18.09.2015 12:56:38