Safety Measures - Vitek VT-1198 ST Betriebsanweisung

APPLIANCE FOR HEATING LIQUIDS VT-1 198 ST
The appliance for heating liquids (thermopot) is
intended for boiling water only. For proper and
safe use of the unit read these instructions care-
fully.
DESCRIPTION
Low water level mark «MIN»
1.
Illuminated water level scale
2.
Lower water dispensing button
3.
Spout for water pouring
4.
Display
5.
Control panel
6.
Upper water dispensing button
7.
Lid opening button
8.
Steam release openings
9.
Lock
10.
Removable upper lid
11.
Carrying handle
12.
Lid axis
13.
Maximal water level mark «FULL»
14.
Body
15.
Power cord connection socket
16.
Power cord
17.
Rotary base
18.
Control panel
Water boiling/re-boiling ON-button «Boil/Stop»
19.
Heating temperature selection button
20.
«Temperature selection»
Water boiling mode/temperature mainte-
21.
nance mode indicator
Power saving mode indicator
22.
Light sensor
23.
Unlocked water dispensing indicator
24.
Delayed start button «Delayed start»
25.
Water dispensing lock/unlock button
26.
«Unlock»
Display
Water temperature indication
27.
Delayed start time indication
28.
Set water temperature indication
29.
ATTENTION!
For additional protection it is reasonable to install
a residual current device (RCD) with nominal
operation current not exceeding 30 mA, to install
RCD, contact a specialist.

SAFETY MEASURES

Before using the thermopot, read this instruction
manual carefully and keep it for future reference.
VT-1198.indd 3
Use the unit for intended purposes only, as speci-
fied in this instruction manual. Mishandling the
unit can lead to its breakage and cause harm to
the user or damage to his/her property.
• Make sure that the operating voltage of the
unit corresponds to the voltage of your mains.
• The power cord is equipped with a «euro-
plug»; plug it into the socket with a reliable
grounding contact.
•
To avoid the risk of electric shock, do not use
adapters for connecting the unit to the mains.
• Do not use the unit in bathrooms. Do not use
it near swimming pools or other containers
filled with water.
•
Do not use the thermopot near heat sources
or open flame.
• Place the thermopot on a flat stable surface;
do not place the unit on the edge of the table.
• Do not place the unit near walls or furniture,
the distance between the unit and any other
surface should be at least 30 cm.
•
Do not use the unit outdoors.
•
Do not connect or disconnect the power cord
with wet hands, this may cause electric shock
or injuries.
• Make sure that the power cord does not hang
from the edge of the table or touch hot sur-
faces.
•
When unplugging the unit, pull the plug but
not the cord.
• Do not switch the unit on without water.
•
Use the thermopot only for water boiling; it
is prohibited to heat or boil other liquids in it.
•
Ensure that the water level is not below the
minimal mark and not above the maximal
mark.
•
Do not refill the thermopot during boiling or
right after it.
•
Do not fill the thermopot with water directly
from the faucet; to fill the thermopot use a
suitable bowl.
•
Do not drop, overturn or tilt the unit.
• Do not leave the operating unit unattended.
•
Do not open the lid and do not dispense water
during boiling.
•
Do not rotate the unit from side to side when
turning water dispensing on.
•
Close the lid properly, but without excessive
effort.
• Keep your hands away from steam release
openings and do not bend over them, it may
cause scalding. Do not block the steam
release openings with any foreign objects.
3
ENGLISH
18.09.2015 12:56:38