Herunterladen Inhalt Inhalt Diese Seite drucken

Vitek VT-1198 ST Betriebsanweisung Seite 4

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 7
ENGLISH
Do not lift the unit by the carrying handle dur-
ing boiling, as it may cause burns by outgoing
steam. Do not open the lid of the unit during
and right after water boiling.
Do not touch hot surfaces of the thermopot.
Be careful while carrying the unit filled with
boiling water, do not press the lid opening
button.
Do not carry the thermopot holding it by the lid
opening button.
Before pouring out remaining water, let the
unit cool down, then remove the thermopot lid
and pour out the water.
To avoid the risk of electric shock, do not
immerse the unit, the power cord and the
power plug of the unit into water or other liq-
uids. Unplug the thermopot in case you don't
use it and before cleaning.
Do not wash the thermopot in a dishwashing
machine.
Before taking the thermopot away for storage
and before cleaning, unplug the unit, pour out
water and let the unit cool down and dry.
For children safety reasons do not leave poly-
ethylene bags used as a packaging unattended.
Attention! Do not allow children to play with
polyethylene bags or packaging film. Danger of
suffocation!
Do not allow children under 8 years of age
to touch the unit body, the power cord or the
power plug during operation of the unit.
Do not leave children unattended to prevent
using the unit as a toy.
Close supervision is necessary when children
under 8 years of age or disabled persons are
near the operating unit.
This unit is not intended for usage by children
under 8 years of age.
Children aged 8 years and over as well as dis-
abled persons can use this unit only if they are
under supervision of a person who is respon-
sible for their safety and if they are given all
the necessary and understandable instruc-
tions concerning the safe usage of the unit
and information about danger that can be
caused by its improper usage.
To avoid damages, transport the unit in the
original package only.
Never use the unit if the power cord or the
power plug is damaged, if the unit works
improperly or after it was dropped.
Do not repair the unit by yourself. Do not dis-
assemble the unit by yourself, if any mal-
VT-1198.indd 4
function is detected or after it was dropped,
unplug the unit and apply to any authorized
service center at the contact addresses given
in the warranty certificate and on the website
www.vitek.ru.
Keep the unit out of reach of children and dis-
abled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD
USAGE ONLY
BEFORE THE FIRST USE
After unit transportation or storage at low
temperature keep it for at least three hours
at room temperature before switching on.
Unpack the thermopot and remove any stick-
ers that can prevent its operation.
Check the thermopot for damages, do not use
it in case of damages.
Before switching on, make sure that the oper-
ating voltage of the unit corresponds to the
voltage of your mains.
How to open, detach and install the
thermopot lid:
Press the lid opening button (8) and, holding the
lifted part of it, open the removable upper lid (11)
about halfway, then holding the thermopot with
the second hand, pull the lid towards the control
panel (6) and remove it.
To install the lid (11) in place, insert the lid axis
(13) in the lock (10) and press the lid from above
to the «click».
Open the lid (11).
Fill the thermopot with water using a suitable
bowl, do not exceed the maximal water level
mark (14) «FULL».
Insert the power cord connector (17) into the
socket (16) on the unit body, and insert the
power plug into the mains socket.
The thermopot will automatically be switched
to the boiling mode, the indicator (21) will light
up red on the control panel (6). At the same
time, the display (5) will show the current
water temperature (indicator 27).
After the water in the thermopot starts boil-
ing, the unit will be switched to the keep warm
mode, the indicator (21) will change the color
of light from red to yellow.
After the first boiling, drain all the water; to
do this, you must unlock the activation of the
water pump by pressing button (26) «Unlock»,
the indicator will light up (24).
4
18.09.2015 12:56:38

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis