Extension Cords; Intended Uses - Work Sharp WSKTS-1 Bedienungsanleitung

User's Guide
Motor
Be sure your power supply agrees with nameplate marking. 230 Volts AC
only means your tool will operate on standard 50 Hz household power. Do not
operate AC tools on DC. A rating of 230 volts AC/DC means that your tool will
operate on standard 50 Hz AC or DC power. This information is printed on the
nameplate. Lower voltage will cause loss of power and can result in over-
heating.

Extension Cords

When using an extension cord, be sure to use one heavy enough to carry the
current your product will draw. An undersized cord will cause a drop in line
voltage resulting in loss of power and overheating. The following table shows
the correct size to use depending on cord length and nameplate ampere rating.
If in doubt, use the next heavier gage. The smaller the gage number, the
heavier the cord.
SAVE THESE INSTRUCTIONS
Volt
120V
230V
Ampere Rating
More Than Not More Than
0
6
10
12
Noise and Vibration Measurements:
Noise (measured values per EN IEC 60745-2-4; IEC 60745-1; EN ISO 3744)
A-weighted sound pressure level Lpa ........................................................65db(A)
Uncertainty factor K ..................................................................................0.1
A-weighted sound power level Lwa ...........................................................65db(A)
Uncertainty factor K ..................................................................................0.2

Intended Uses:

• Grinding, Sharpening and Honing applications on knives and tools.
• Light duty grinding in metal.
• Only for use with consumer applications.
Minimum Gauge for Cord Sets
Total Length of Cord in Feet
0 - 25
(0-7.6 m)
0 - 50
(0-15.2 m)
6 18
10 18
12 16
16 14
26-50- 51-100
(7.6-15.2 m) (15.2-30.4 m)
51-100 101-200
(15.2-30.4 m) (30.4-60.9 m)
American Wire Gauge
16
16
16
12 Not Recommended
101-150
(30.4-45.7 m)
201-300
(60.9-91.4 m)
16 14
14 12
14 12
9