Work Sharp WSKTS-1 Bedienungsanleitung Seite 8

8
• WARNING:
Use of this tool can generate and/or disperse dust, which may
cause serious and permanent respiratory or other injury. Always use NIOSH/
OSHA approved respiratory protection appropriate for the dust exposure.
Direct particles away from face and body.
• CAUTION:
Wear appropriate hearing protection during use. Under some
conditions and duration of use, noise from this product may contribute to hearing
loss.
• Hold tool by insulated gripping surfaces when performing an operation
where the abrasive belt may contact hidden wiring or its own cord. Contact
with a "live" wire will make exposed metal parts of the tool "live" and shock
the operator.
• Always hold tool firmly.
• Use clamps or another practical way to secure and support the work piece
to a stable platform. Holding the work by hand or against your body leaves
it unstable and may lead to loss of control.
• Avoid prolonged contact with dust from power sanding, sawing, grinding,
drilling, and other construction activities. Wear protective clothing and
wash exposed areas with soap and water. Allowing dust to get into
your mouth, eyes, or lie on the skin may promote absorption of harmful
chemicals.
SAFETY GUIDELINES — DEFINITIONS
It is important for you to read and understand this manual. The information it
contains relates to protecting YOUR SAFETY and PREVENTING PROBLEMS.
The symbols below are used to help you recognize this information.
• DANGER:
Indicates an imminently hazardous situation which, if not
avoided, will result in death or serious injury.
• WARNING:
avoided, could result in death or serious injury.
• CAUTION:
Indicates a potentially hazardous situation which, if not avoided,
may result in minor or moderate injury.
Used without the safety alert symbol (•) indicates a potentially
CAUTION:
hazardous situation which, if not avoided, may result in property damage.
The label on your tool may include the following symbols.
V .................. Volt
Hz ................ Hertz
min ............... minutes
............. direct current
............... Class II Construction
•
............... safety alert symbol
.......................
Indicates a potentially hazardous situation which, if not
Work Sharp Knife & Tool Sharpener
A .............amperes
W ............watts
...........alternating current
n o ............no load speed
...........earthing terminal
rpm .........revolutions or
reciprocations per minute