Protection Circuits - Zeus audio SPL-P2100 Gebrauchsanleitung

Congratulations to the purchase of this ZEUZ car amplifier. Read this manual carefully prior to
installing the unit.
Warning
- Keep this manual for future reference.
- Prior to using the unit, have the installation checked by a qualified technician.
- The amplifier produces very high sound volumes. Never set the amplifier to its maximum level
to avoid hearing damage.
- Always reduce the volume to the minimum prior to switching the unit off.
- Always connect the ground wire to the car chassis or another grounding point.
- Keep the packaging so that the unit can be shipped in the original packaging in order to avoid
damage.
- During installation or maintenance, switch the car engine off.
- Do not obstruct the ventilation holes. Keep away from humidity.
- Clean only with a damp cloth. Never use cleaning products.
- The unit does not contain any user replaceable parts other than those specified in this manual.
- The amplifier can get very hot during operation. Do not touch it during use and let it cool down
for at least 15 minutes prior to touching it.
- In case of a problem, contact your dealer.
- Prior to mounting the unit, make sure that you will not damage any other cables.
- The unit must be powered directly from the battery. For safety reasons, insert an in-line fuse
into the power lead connected to the positive terminal of the battery.
- It is recommended to use the unit only when the engine is running in order to prevent
discharging the battery
- Keep out of the reach of children.

Protection circuits

This amplifier features two protection circuits: one against overheating and one against inverted
polarity of the power or speaker cable. In both cases, the LED will light up in red. Switch the amplifier
off and let it cool down and solve the problem.
Ensure sufficient ventilation. Do not put any objects on the amplifier and keep the ventilation holes free.
The speaker outputs are protected against malfunctioning of the speakers or speaker cable. If the LED
lights up in red and the sound signal is muted, switch the amplifier off and check the cables and
speakers.
The LED lights up in green if the amplifier is powered.
GB