Operating Elements; Powerbox (Welding Power Source); Sdv (Separate Wire Feed Unit); Swk - Elektra Beckum MIG MAG 232 EP Betriebsanleitung

For machine performance see "Techni-
cal Specifications".
Any other use is not as specified and
prohibited.
The manufacturer is not liable for any
damage caused by unspecified use.

3. Operating Elements

3.1 Powerbox
(welding power source)
1
2
1
Connection (front) for earth
cable (- Pole).
2
Main switch
switches the Powerbox and all
devices connected to it ON or OFF.
3
9
3
Power supply outlet for addi-
tional devices
Rating: 10 A / 230 V.
4
Bracket with chain
secures the gas cylinder against
turning over.
5
Pilot lead
for SDV.
6
7
8
9
3.2 SDV (separate wire feed
unit)
14
10
11
4
12
5
13
14
6
7
8
21
Power cable
SDV motor. When using a SWK the
power supply cable is connected to
the SWK. The SDV then automati-
cally controls the water cooling
when welding.
Welding cable
with cable connector (+ pole).
Connection (rear) for earth cable
(- pole).
Power supply cable
with CEE plug.
13
12
11
10
Euro connector socket for weld-
ing gun
for connection of all commercially
available welding guns.
Connection for coolant runback
from welding gun.
Connection for coolant feed to
welding gun.
Connector socket for pilot lead
of external devices.

Control unit.

Selection, display and setting of the
operating parameters.
The control unit for the machine's
default settings is located inside the
SDV.
20
19
15
Connection for shielding gas
line
16
Connector socket for exteral
programming
17
Connector socket for power sup-
ply
18
Connector plug for welding cur-
rent supply
19
Connection for coolant runback
into SWK.
20
Connection for coolant feed from

SWK.

21
Connector socket for pilot lead
3.3 SWK (separate water-
cooling unit)
The SWK is automatically controlled by
the Powerbox.
Note:
Instructions on how to connect
and operate the SWK are given in the
separate instructions supplied with the
device.
3.4 Control unit
22
25
26
15
22
Parameter selection (momen-
tary contact switch)
16
for selection of the parameter to be
displayed and/or adjusted.
The LEDs [
17
selected parameter.
23
LED wire feed [m/min]
18
24
LED welding current [A]
ENGLISH
23
24
27
28
23 26
- ] indicate the
13