Safety Information; Proper Use - EINHELL GH-PW 18 Originalbetriebsanleitung

Anleitung_GH_PW_18_SPK7__ 28.08.13 10:56 Seite 15
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.

1. Safety information

Please refer to the booklet included in delivery for the
safety instructions.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout (Fig. 1/2)
1 Petrol tank
2 Carry handle
3 Filler neck
4 Pressure connection
5 Suction connection
6 Drain screw
7 Oil filler screw / Oil dipstick
8 Oil drain plug
9 Starter cord
10 On/Off switch
11 Air filter
12 Intake cage
13 Oil filler funnel
14 Spark plug wrench
15 Open-ended spanner (8/10 mm)
16 Screwdriver
17 2x Union nut
18 2x Seal
19 2x Hose connector 1.5"
20 2x Threaded connector 1" external thread
21 3x Hose clip

3. Proper use

The machine is suitable for irrigating and watering
landscaped areas, vegetable beds and gardens and
for operating lawn sprinklers.
The water can be taken from ponds, streams,
rainwater butts, rainwater cisterns and springs if an
initial filter is fitted.
The maximum temperature of the fluid must not
exceed +35°C if the machine is operated
permanently.
Clean water (sweet water), rainwater and low
concentrations of washing lye can be used as the
transport medium. The machine must not be used to
transport inflammable, gassing, explosive and
aggressive fluids (such as petrol, acids, lyes, silo
percolating juice, etc.) and fluids that contain
abrasive substances (such as sand).
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
GB
15