Korg TONEWORKS PANDORA PX4B Bedienungsanleitung Seite 33

Bass Synth parameters
Oscillator selection:
0...15 (BASS knob)
S.T. = Sawtooth
VCF setting: 0...10.0
(MIDDLE knob)
Direct level: 0...10.0
(TREBLE knob)
Synth level: 0...10.0
(VOLUME knob)
Threshold adjustment:
1.0...10.0 (Value dial)
The Bass Synth is effective only when single notes are played. The desired effect will not be obtained if
chords are played.
If your instrument is not tuned correctly, the results may not be as you expect. In this case, re-tune your
instrument.
0: S.T. wave, 1 octaves down. 1: S.T. wave with resonance, 1 octave down.
2: S.T. wave.
4: S.T. wave, 1 octave up.
6: S.T. wave, 2 octaves up.
Oscillators 8...15 are oscillators 0...7 with portamento turned on.
Voltage Controlled Filter sensitivity adjustment.
0...4.7 is sensitivity adjustment in the positive (+) direction,
and 5.0...10.0 is sensitivity adjustment in the negative (-) direction.
Adjusts the volume of the bass.
Adjusts the volume of the synth.
Adjusts the sensitivity of the synth in response to the volume of the bass
Adjust this as appropriate for your bass or pickup.
3: S.T. wave with resonance.
5: S.T. wave with resonance, 1 octave up.
7: S.T. wave with resonance, 2 octaves up.
33