Setting The Date And Time; Using Headphones - Roland R-07 Bedienungsanleitung

Getting Ready

3. Setting the Date and Time

After you turn on the power for the first time, you'll need to set the
internal clock as follows. The date and time you specify are used as
the time stamp for the files that are recorded.
1. Press [MENU] to access the "Menu" screen, use [
to select "Date & Time," and press [ ].
NOTE
• The internal clock is powered by batteries. If the R-07 is left for
several hours with batteries removed, the internal clock will return
to its default state. When you turn on the power in this state, the
message "Clock Initialized" will appear.
• If the screen indicates "Clock Initialized, " you'll need to reset the
date and time.
2. Set the date and time.
Use [ ]/[ ] to move the cursor left/
right.
When the cursor is at the position of the
character you want to change, use [
time, and press [ ] to confirm the setting.
3. Press [MENU] to return to the main screen.
10

4. Using Headphones

The R-07 has a built-in speaker. You can listen to the playback
through this speaker, or you can connect headphones for listening.
You can also connect Bluetooth headphones to the R-07 and listen
wirelessly to the playback.
]/[ ]
* To prevent malfunction and equipment failure, always turn
down the volume, and turn off all the units before making any
connections.
Connecting Bluetooth® Headphones
Supported codecs: SBC, Qualcomm® aptX™ audio,
Qualcomm®aptX™ Low Latency audio
Registering a Bluetooth device (Pairing)
"Pairing" is the procedure by which the mobile device that you want
to use is registered on this unit (the two devices recognize each
other).
Once a mobile device has been paired with this unit, there is no
]/[ ] to change the date and
need to perform pairing again. After the R-07 starts, it searches for
the previously-connected device, and connects automatically.
1. Place the Bluetooth device that you want to connect
near the R-07, power-on the device, and put it in pairing
mode.
For details, refer to the owner's manual of your Bluetooth device.
2. Press [MENU] to access the "Menu" screen, use [
to select "Bluetooth," and press [ ].
3. Use [ ]/[ ] to select "Pairing Audio" and press [ ].
]/[ ]