Connecting Network - Panasonic CZ-TAW1 Anleitung

Connecting Network

You can establish a connection with the internet with either the Ethernet
mode (wired) or the Wireless mode (wireless).
1 Turn on the power supply to the indoor unit.
∙ The Power LED lights.
2 The colour of the Status LED indicates the connection mode�
■
When connecting using the Ethernet mode (wired)
1 Check the Status LED is green to confirm that the
Ethernet mode is on�
∙ If the Ethernet mode is not on, press and hold the Check switch for
10 seconds to switch to the Ethernet mode.
2 Connect the router and the adaptor with a LAN cable.
∙ The Link LED lights to indicate that the connection has been established.
∙ Use a shielded LAN cable.
■
When connecting using the Wireless mode (wireless)
1 Check the Status LED is blue to
confirm that the Wireless mode is
on�
∙ If the Wireless mode is not on, press and
hold the Check switch for 10 seconds to
switch to the Wireless mode.
2 Switch on WPS on the router.
3 Press the WPS switch on the adaptor.
∙ The Status LED and Link LED light when communication is established.
* Refer to Troubleshooting (P.12), "When you cannot connect in the
Wireless mode" or "When you cannot connect in the Ethernet mode" when
you cannot connect to the network.
Power LED
Status LED
The colour of the Status LED changes each time the Check
switch is pressed and held for 10 seconds.
Status LED: Green (Ethernet mode)
Status LED: Blue (Wireless mode)
WPS switch
11