OHAUS EX124 Anleitung Seite 5

Side Door Installation
1. Unlock
3. Clear
Position glass door to slide. Open lock tab (top); insert in top groove and slide
inside bottom groove. Close lock tab.
Front Panel Installation
1. Release terminal
3. Push to rear
Press button to separate Terminal from Base. Seat panel's hooked ends in base. Swing panel to vertical position.
Top Door Installation
1. Align 2.
Insert Top Door's hooked ends in grooved pegs. Press gently to seat. Check for smooth movement. Close door.
2.8 Installing the Weighing Pan & Wind Shield – Non-Draft Shield Models
Note: Assembly instructions also apply to models with the suffix M or N.
1. Place the four Support Caps onto the Balance as shown.
2. Place the Weighing Pan on the Support Caps
3. Place the Wind Shield onto the Balance as shown.
Note: The balance can be operated without the Wind Shield. However, depending on ambient conditions the displayed results
may be slightly less stable.
2. Align
4. Lock
2. Align
4. Reconnect terminal
Press Down
EN-3