Preparing The Remote Control Unit - Loewe One 55 Installationsanleitung


One 40-55
Installation instructions
Operating controls on the TV set

Preparing the remote control unit

Functions of the operating controls One 55 / One 40
2
3
1
Mains switch:
The mains switch is located on the bottom of the set.
Always return the TV set to Standby mode before switching it off
with the main switch.
2
Display:
white:
white, intermittent: TV set starts.
green:
red:
blue:
3
IR receiver:
Infrared receiver for receiving the remote control commands.
4
Key M (One 55) / joystick direction M (One 40):
TV set in standby mode: switch on TV set with the last selected
TV set switched on: call direct control on TV set.
Direct control on TV set: up .
5
Key R (One 55) / joystick direction R (One 40):
TV set in standby mode: switch on TV set with the last selected
TV set switched on: toggle TV mode and radio mode.
Direct control on TV set: down .
6
36592001_QG_One_40-55_2_GB_00_Buch.indb 6 36592001_QG_One_40-55_2_GB_00_Buch.indb 6
4 M
5 R
V+
6
7 V-
P+
8
6 4
9 P-
1
M
_
10 +
R
One 55
One 40
TV set in standby.
TV set switched on.
timer recording active.
TV set in standby and background operation
active (EPG data updating, software
update).
mode (TV/Radio).
mode (TV/Radio).
6
Key V+ (One 55) / joystick direction + (One 40):
TV set in standby mode: switch on TV set with the last selected
TV set switched on: Increase volume.
Direct control on TV set: to the right .
7
Key V– (One 55) / joystick direction – (One 40):
TV set in standby mode: switch on TV set with the last selected
TV set switched on: Reduce volume.
Direct control on TV set: to the left .
8
Key P + (One 55):
TV set switched on: Programmme + (next station).
9
Key P – (One 55):
TV set switched on: Programme – (previous station).
10
On/Off button (One 55) / Press joystick (One 40):
Switching on in standby mode
10
Switching off to the standby mode
7
5
Preparing the remote control unit
Inserting or replacing batteries
Press on the embossed arrow whilst pushing the battery cover down.
Only use leak-proof micro-cells of the LR 03 (AAA) Alkali-Manganese
type. Do not use different types of batteries and old and new batteries
together.
The batteries used must not be exposed to excessive heat such as
sunlight, fire or similar!
The position of the batteries is indicated in the battery compartment
(in opposite directions). Pay attention to the correct polarity of +
and – when inserting the batteries.
If the batteries are too weak after longer use, the TV set prompts you to
change the batteries. Dispose of used batteries in an environmentally
friendly way (see chapter Environment / Legal information).
Push the cover back on from below after having inserted the batteries.
Adjusting the remote control unit for operating the TV set
Press the TV key.
mode (TV/Radio).
mode (TV/Radio).
06.04.2016 16:33:07 06.04.2016 16:33:07
