Hydro-Pro Inverter 10 Benutzer- Und Wartungshandbuch Seite 22

TIME setting
Press first ,then press the
enter into "HOUR" setting. The "Hour " flashes, and press the
to save the "Hour". Then the " Minute" flashes, and press the
press the to save the current time setting , or press
Timer On setting:
The operation is the same to TIME setting after you entering into the 'Time of automatic start' interface.
Once done, the light
Timer off setting:
The operation is the same to TIME setting after you entering into the 'Time of automatic stop' interface.
Once done, the light
Cancel Timer ON/OFF
When you set Timer ON/OFF data 00:00, it means cancel the Timer ON/OFF function.
ATTENTION: Above operations, you could press
* Noted:
* In order to heat the water in the pool (or hot tub), the filter pump must be running to cause the water to circulate
through the heat pump. The heat pump will not start up if the water is not circulating. If the water is not circulating
and the Heat Pump is ON the LED controller inform with the error code ON
* LED wire controller can operate the water pump after connected additional cable to the pump device in the
position of "PUMP" terminal accurately.
* When HP stop running in 30 seconds, water pump will shut off automatically
6.2.4 System reset function
Press and
6.2.5
Symbol of heating, the light will be on when it is in operation.
to enter into "Current time " displaying . Then press
will display.
will display.
in 10s, the system will reset and display "0000" on the controller.
or
or
for quick‐exit and saving.
to save the setting and quick‐exit the program.
- 18 -
once again to
to set the hour ,then press
to set the "Minute" and finally