Troubleshooting - VESTEL AC 3-Phase 22kW Benutzerhandbuch

TROUBLESHOOTING

PROBLEM
The product button LED is not lit
when it is energized.
The EVC does not start charging
EV although the button LED is
blue.
The product does not lock the
cable in charging state.
The button LED is blinking red.
The button LED is steady red.
POSSIBLE REASONS
There might be power outage or
the circuit breaker can be tripped.
The charging cable might not be
connected properly to the EVC
and EV. The EV is not in
charging state or its battery is
full.
The charging cable might not be
connected properly to the EVC
and EV.
Your car needs ventilation during
charging because of the
drivetrain battery type. This EV
charger unit is intended only
for charging electric vehicles
not requiring ventilation during
charging.
The AC supply voltage might not
be in the range that is specified
in the user manual or the EVC
device might have an internal
fault.
English - 11 -
SUGGESTED
SOLUTIONS
Check circuit breaker whether it
is tripped or not and be sure that
the charger is energized properly.
Be sure that charging cable is
connected properly to both sides.
Please check your EV if it is in
charging mode or not.
Be sure that cable is connected
properly. If the problem still
continues, please consult the
service.
You need to use appropriate
EVC in connection with an
appropriate ventilation unit for
charging your car.
Please be sure that the voltage
is in the desired range. Press the
button at least 5 seconds to clear
fault of the EVC. If the button is
still steady red, please consult
the service.