Istructions For Use - Lega 6710 Bedienungsanleitung

3.2 CONTROL PANEL ASSEMBLY INSTRUCTIONS
The warming cabinet is supplied with the control panel secured on the rear panel.
Before turning the machine on and using it, remove the control panel and install it in its correct position.

ISTRUCTIONS FOR USE

3.3
3.3.1 Preliminary operations before use
Place the cans or drums on a bench of suitable dimensions or on boards, placed a few centimeters above
ground, so to ensure adequate warming up of the bench or the boards bottom.
Place the cans one above the other and intercrossed, so to have the greatest area possible of the containers
exposed to heat.
3.3.2 Operating instructions
The thermoregulator on the control panel has four control keys and one display.
After the warming cabinet has been turned on via the main switch and the start button has been pressed, the
cabinet inside temperature is displayed on the screen.
By pressing the SET key the preset maximum allowed temperature is shown.
To change this temperature setting, press the SET key then press the key with the arrow pointing UP to increase
the temperature degrees or the key with the arrow pointing DOWN to decrease them.
Now the two resistors inside the heating elements start warming up.
Costruzioni Apistiche – via Maestri del Lavoro 23 – 48018 Faenza
www.legaitaly.com - Tel 054626834 – Fax 054628279 – P.iva 00043230390
To do so, loosen the screws of the control panel support using a 5
Allen key.
Turn it upside down then
secure it in position on the
front panel by tightening the
screws.
The correct assembly is
shown in the picture below.
CAUTION! The thermoregulator is set at a temperature of 45°C.
Higher temperatures may damage the product.
12 / 30