Setting The Cutting Parameters; Wheel; Speed; Feed - struers Accutom-5 Gebrauchsanweisung

Setting the Cutting Parameters

Method Screen

Wheel

Speed

Feed

Force

18
Accutom-5
Instruction Manual
All cutting parameters can be edited independently of each other.
See section Changing/Editing values for details on how to change
values.
Cutting Method: 1. EMPTY METHOD
Wheel : B0D15 Speed
Feed :0.100 mm/s Force
Rotation: CONT. Speed: 1
Water : ON
F3:TEST ROTATION F4:SAVE
All Struers cut-off wheels are listed with their default values for force
limit, wheel thickness and speed. Also eight undefined wheels are
included for your own choice of cut-off wheels. (See also
configuration of cut-off wheels).
The speed of the cut-off wheel can be set between 300 and 3000
rpm in steps of 100 rpm. The default values for all Struers cut-off
wheels are already saved together with the wheel definitions.
Whenever a different cut-off wheel is selected the recommended
speed will automatically be inserted.
The feed speed can be set between 0.005 mm/s and 3.000 mm/s.
(See the section Cutting Parameters in chapter 3. Consumables for
recommended settings).
The force limit is a protection for the cut-off wheel and/or the samples
to be cut. Depending on the thickness or strength of the cut-off
wheels the force limit can be set to three different levels, LOW,
MEDIUM and HIGH. The default values for all Struers cut-off wheels
are already saved together with the wheel definitions. Whenever a
different cut-off wheel is selected, the recommended force limit will
automatically be inserted.
Sample rotation can be an advantage when cutting large, very hard,
coated or very long samples. On Accutom-5, three different settings
are possible.

: 2700 rpm
: MEDIUM
Dir.: > <