Herunterladen Inhalt Inhalt Diese Seite drucken

Cleaning And Maintenance; Periodic Cleaning; Periods Of Inactivity; Troubleshooting - AEG KBK994519M Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

14
www.aeg.com

8. CLEANING AND MAINTENANCE

8.1 Periodic cleaning

The appliance must be cleaned regularly.
Avoid pulling, moving or damaging
pipes and/or cables inside the appliance.
To clean the internal parts, do not use
detergents, abrasive powders, products
with strong fragrances or polishing waxes
as they may damage the surface and
leave an intense odour.
• Wash the internal surfaces with
a solution of warm water and
bicarbonate. Use 2 tablespoons of
bicarbonate for one litre of water.
• Wash the shelves with a neutral
detergent.
• Wring out excess water from the
sponge or cloth before cleaning
near the controls or any electrical
component.
• Wash the inside and the accessories
with warm water and neutral soap.

9. TROUBLESHOOTING

CAUTION!
Refer to the chapters on safety.
9.1 What to do if...
Problem
The appliance does
not turn on.
Presence of ice in
the cavity.
Excessive formation
of water at the
bottom of the cavity.
Displayed message
"close the door
to continue the
program".
Possible cause
No power supply.
The appliance has been used
for too long.
Intensive use of the appliance
and subsequent de-icing.
The door is not closed properly.
• Inspect the door gaskets regularly and
remove any traces of dirt and residues
with a damp cloth.
• Rinse and dry thoroughly.
Be careful not to damage the cooling
system.
After cleaning, reconnect the appliance
to the mains.

8.2 Periods of inactivity

If the appliance is not used for a long
time, take the following precautions:
• disconnect the appliance from the
mains;
• remove all the accessories;
• clean the appliance and all the
accessories;
• leave the door open to prevent the
formation of unpleasant odours.
Solution
Check the electrical connection.
Run a de-icing cycle with the
door open.
Turn the machine off at the end
of the cycle.
Use the sponge provided to dry
the cavity.
Check that the gasket
supporting surface is clean.
Remove any ice from the door
frame/gasket.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis