Operating Mode - Siemens WTT665 Serie Bedienungs- Und Installationsanleitung

Operating mode

Switch on device
Press and hold the on/off switch
After the device has powered on, the device and battery status is indica-
ted by the LED
Make sure you have enough battery capacity. If battery status
has reached minimum, theWTT665.. cannot be switched on. In
this case, the battery has to be charged for at least 30 minutes.
Create communication
Ensure that the mobile computer features a Bluetooth option. Start the
software (e.g. ACT46.PC) on your mobile computer.
In the program, activate the "Bluetooth" communication mode. Establish
a connection to the WTT665.. by searching for a Bluetooth device in the
software.
The search results might indicate a number of Bluetooth devices.
The WTT665.. can be identified by its 8-digit number. This number
(device ID) is indicated on a type label attached to the back of
theWTT665...
From the program, select the device with your 8-digit ID.
As soon as a connection is established between the mobile computer
and the WTT665.., the LED
In the status line at the bottom, the program (e.g. ACT46.PC) will show
your WTT665..as a communication partner.
Now WTT665..is ready for use. Upon request (readout with/without
list), the consumption data sent by the measuring devices are directly
transferred to the mobile computer.
During active transmission, the LED
ly at 1-second intervals.
The WTT665.. does not store any consumption data. The
measuring device data is directly transmitted to the software.
EN
32
4 and 2 .
A6V10986929__----__a
5
for more than 3 seconds.
on the WTT665.. briefly flashes blue.
4
on the WTT665.. flashes steadi-
4
Siemens Building Technologies