Virax V 150+ Bedienungsanleitung Seite 22

8 – Type of use and speeds
•
Drilling for reinforced concrete, stone, etc.:
- The water intake mechanism must be used.
-
Raised hand: Ø 25 mm - 82 mm.
-
With support stand: Ø 25 mm - 152 mm.
•
Drilling for masonry work (bricks, breeze blocks, etc.), aerated concrete,
limestone, etc.
- The use of a dust vacuum mechanism is strongly recommended.
-
Raised hand or with support stand: Ø 25 mm - 122 mm.
-
With support stand: Ø 25 mm - 200 mm
Type of used
CONCRETE --> WET CORE DRILLING
Raised hand or with support
stand
On support stand only
MASONRY --> DRY CORE DRILLING
Raised hand or with support
stand
Raised hand only
•
Speed change:
Turn the speed selector to the next speed up or down. If you cannot change speed
easily, you may turn the tool holder shaft gently. Change speeds only WHEN THE
MACHINE IS STOPPED.
Warning!
!
▪
Never change speeds violently. Always change speed when the
motor is off and disconnected from the electricity network.
▪
Do not use pliers, a hammer or any other tool to change speed.
Diameter used
(vacuum recommended)
22
25 - 42
42 - 82
82 - 152
25 - 62
62 - 122
122 - 152
152 - 200
-EN-
SPEED
3
2
1
3
2
1
1