AVer VC520 Bedienungsanleitung Seite 7

b. Minimize: Minimize the app to system tray. To quit the application,
right-click the icon on the system tray and select "Quit".
d. Connection diagnostic: Display devices connection status. If the AVer PTZ app has detected that some
of the devices (camera, speakerphone, hub, and laptop/PC) are not connected well, the diagram will
display an "X" on the device to indicate the connection has a problem. If the camera is in use by another
application, it will display "Can't start video" warning.
e. Test Camera: Click the "Test Camera" button to check the camera video display status. You can adjust the camera direction and view of the zoom
in/out. To leave the page, click the Abort Diagnostic button.
f. Test Speakerphone: Click to check the speakerphone status. It will require the user to record a short message and play it back to ensure the
speakerphone is working.
g. Update Now: Allows the user to update the VC520 camera's firmware.
1. Click" Update Now".
2. A dialog will display the current firmware version and available new firmware version (internet connection is required).
3. To auto update, click "Auto Update" and update process will start. The new firmware will be downloaded first; then, the new firmware will be uploaded
to camera.
[Note] Before updating the new firmware to the camera, please make sure camera, hub, and laptop/PC are all well connected and stay connected
during the entire process.
4. To update the firmware manually, click "Manual Update" and locate the new firmware to start the process.
c.
view the camera live view. Click the
camera icon again to close the
camera live view. If the live video did
not appear, please check the camera,
hub, and the laptop/PC connection to
make sure all are correct and well
connected.
© 2015 AVer Information Inc. All rights reserved.
English-6
/
(Camera): Click it to