Installation - Toshiba TCB-IFGSM1E Installationsanleitung

TCS-NET GSM Phone Control Interface
4

Installation

TCB-IFGSM1E Installation Method and Orientation
There are five orientations of Surface/Wall Mount that the TCB-IFGSM1E can be installed, these are shown below.
NOTE
Please use screws supplied for installation of device.
Remove the screws at the four corners, fix the supplied plastic external mounting feet, and then tighten the supplied
MT-34K screws to secure the case, feet, and case lid together. Then secure the TCB-IFGSM1E to a wall with
screws using the holes B.
Secure the case lid and the external
mounting feet with the same supplied
MT-34K screws.
REQUIREMENT
Do not install the unit in any of the following places.
• Humid or wet place
• Dusty place
• Place exposed to direct sunlight
• Place where there is a TV set or radio within one meter
• Place exposed to rain (outdoors, under eaves, etc.)
Installation Space and Maintenance Space
A side space for connecting through cable inlets and an upper space for
maintenance must be reserved before installation.
The other sides can be adjacent to surrounding objects.
A
Back Side View of the TCB-IFGSM1E Case
– 9 –
Installation Manual
Screw holes for securing
B
the TCB-IFGSM1E
No good
100mm
EN
100mm
100mm
8-EN