Toshiba TCB-IFGSM1E Installationsanleitung Seite 17

TCS-NET GSM Phone Control Interface
Checking Communication Using Actual Telephone Network
Connect a GSM modem to the TCB-IFGSM1E and perform a test run using the actual telephone network.
Connecting to GSM modem and temporarily fixing GSM modem location and orientation
Connect the TCB-IFGSM1E to the GSM modem with an RS-232C straight cable, and secure the D-sub connectors
on both ends of the cable to each unit with screws. Also fix the installation position and orientation of the GSM
modem temporarily.
Turn on the power of the GSM modem. Then open the SMS message creation screen on the specified mobile
phone. When the target air conditioner is OFF, create an SMS message by selecting ON and send the SMS
message to the GSM modem telephone number.
After a while, an SMS message with text "SETTING OK" is returned. Check that the indoor unit is turned on.
Then create an SMS message by selecting STATUS and send the SMS message to the GSM modem telephone
number.
When the air conditioner status can be acquired with "NAME:STATUS ON" or "NAME:STATUS OFF," the test run
is successful.
If the setting for the air conditioner is not reflected or the air conditioner status cannot be acquired, SMS message
transmission or reception may have failed due to incorrect destination telephone number, bad wave condition or a
problem of the telephone network. Examine the cause and solve the problem.
If the current GSM modem location or orientation worsens the communication status, find the best location or
orientation and fix the GSM modem temporarily at the point.
Deleting the Telephone Numbers for Test
Before delivering the product to the customer, delete the destination telephone number and the setting permitted
telephone number that were registered for the test run.
Restarting the modem emulator software
Connect the TCB-IFGSM1E to the PC again and restart the modem emulator software.
Deleting the destination telephone number
Enter "DEL INFOTEL ++" (++: mobile phone number for test) in the Message Box, and click the SEND button.
Check that the following message appears in the textbox at the centre of the screen.
[SND] DEL INFOTEL ++++
[SND]OK
Enter "READ INFOTEL [ENTER]" in the Message Box, and click the SEND button.
Check that the following message appears again in the textbox at the centre of the screen.
[RCV] ++++++++ READ INFOTEL NONE
(++++++++: indicates the characters of the registered NAME)
– 17 –
Installation Manual
EN
16-EN