Cleaning The Particle Sensor; Cleaning The Surface Of The Filter (Fig S) - Philips AC3033 Benutzerhandbuch

Cleaning the particle sensor

Clean the particle sensor every 2 months for optimal functioning of the
appliance�
Note:
• If the air purifier is used in a dusty environment, it may need to be cleaned
more often�
• If the humidity level in the room is very high, condensation may develop
on the particle sensor and the air quality light may indicate a more poor air
quality even though the air quality is actually good� If this occurs, clean the
particle sensor�
• The gas sensor doesn't need to be cleaned�
1
Switch off the air purifier and unplug from the power socket�
2
Pull the back cover and remove it from the appliance (fig c)�
3
Clean the particle sensor with a damp cotton swab (fig r)�
4
Dry all parts thoroughly with a dry cotton swab�
5
Reattach the back cover (fig g)�

Cleaning the surface of the filter (fig s)

Filter alert light status
The filter cleaning alert
the screen�
1
Switch off the air purifier and unplug from the power socket�
2
Pull the back cover and remove it from the appliance (fig c)�
3
Pull the filter from the appliance (fig u)�
4
Clean the surface of the filter with a vacuum cleaner (fig t)�
5
Put the filter back into the appliance (fig f)�
6
Reattach the back cover� (fig g)
7
Put the plug of the air purifier in the power socket�
8
Touch the button to switch on the appliance�
9
Touch and hold the filter status check/reset button
reset the filter cleaning time�
10
Wash your hands thoroughly after cleaning the filter�
Action
Clean the surface of the filter with a
displays on
vacuum cleaner�
for 3 seconds to
EN
11