Operating Test; Om-Dragon™ Default Configuration - Datalogic OM-DRAGON series Kurzanleitung

DATALOGIC
UK/US
Romanian
Czechoslovakian

OPERATING TEST

Read the "Test Codes" at the end of this Quick Reference manual.
YOUR SYSTEM IS NOW READY TO READ BARCODES ACCORDING TO
THE DEFAULT CONFIGURATION
OM-DRAGON™ DEFAULT CONFIGURATION
RS232 DEFAULT SETTINGS
9600 baud, parity disabled, 8 data bits, 1 stop bit, handshaking disabled,
ack/nack protocol disabled, FIFO enabled, delay disabled, 5 sec. rx timeout
WEDGE DEFAULT SETTINGS
USA keyboard, caps lock off, num lock unchanged, inter-character and
intercode delay disabled, control character emulation = Ctrl+Shift+key
PEN DEFAULT SETTINGS
Interpret operating mode, conversion to code 39 enabled, output level normal, idle
level normal, minimum output pulse 600µs, overflow medium, interblock delay
disabled
DATA FORMAT
no header, terminator: RS232 = CR-LF; WEDGE = CR, gun and cradle address
stamping and address stamping delimiter disabled
RADIO PARAMETERS
Battery Type: Auto-detect
NETWORK PARAMETERS
RS485 network disabled
14