Kodak SMILE Benutzerhandbuch Seite 9

GETTING READY FOR USE
Charge the SMILE
Before using the printer, connect it to the
charger by plugging the micro USB cable
into the designated micro USB charging port
on the side and allow it to fully charge.
If the red indicator LED light is flashing, this
means that the battery is low and you should
plug the printer in for it to recharge. While
the printer is charging, the indicator LED will
be a solid red light. Once the process has
completed, the indicator LED will change to
a solid green light.
Load the Paper
Load your ZINK paper into the printer: Follow
the steps below to quickly and easily get
your new printer loaded with ZINK sticky-
back paper so you can start printing photos!
1. Open the paper tray in the back by
removing the tray cover at the rear of the
device.
EN | 9