Modem / Hub + Modem - Avtech AVH306 Schnellstart

IP Address:
Ports to Open:
Check your connection
Step1: Open your web browser, e.g. Internet Explorer.
Step2: Enter the NVR address and the port number in the URL address box of the web browser, and see if you
can access the NVR login page successfully.
The format is "http://ipaddress:portnum" or "http://hostaddress:portnum".

4.3 Modem / Hub + Modem

Before configuring, make sure:
 You know you're using static IP address or PPPoE for Internet service.
 For users with static IP address, make sure you get the information of the static IP address, gateway and net mask from your ISP
(Internet Service Provider).
 For users with PPPoE, make sure you get the user name and password from your ISP (Internet Service Provider).
Step1: Connect your NVR to the hub or modem with a RJ45 network cable, similar as follows:
Step2: From your NVR, select
CONNECTION
CAMERA
DETECTION
ALERT
NETWORK
DISPLAY
RECORD
NOTIFY
EXIT
Step3: Select "STATIC", "PPPOE" or "DHCP" based on your network type, and change the port number if
needed.
 For "STATIC", enter the information of the static IP address, gateway and net mask from your ISP.
 For "PPPOE", enter the user name and password from your ISP.
 For "DHCP", go to "Step4" directly for port forwarding.
Note: The default port number is 80. Typically, the TCP port used by HTTP is 80. However in some cases,
it is better to change this port number for added flexibility or security.
The IP address of the NVR, such as 192.168.1.112 in our example.
The port number you set for the NVR, such as 88 in our example.
(ADVANCED CONFIG), and select "Network"  "WAN".
ADVANCED CONFIG
WAN LAN E-MAIL DDNS
NETWORK TYPE
IP
GATEWAY
NETMASK
PRIMARY DNS
SECONDARY DNS
PORT
USER NAME
PASSWORD
PPPOE
192.168.1.112
192.168.1.254
255.255.255.0
168.095.1.1
139.175.55.244
88
head-office
*******
15
NETWORK CONFIGURATIONS