Avtech AVH306 Schnellstart Seite 21

Step2: From your NVR, select
CONNECTION
CAMERA
DETECTION
ALERT
NETWORK
DISPLAY
RECORD
NOTIFY
EXIT
Step3: Select "DHCP", and configure the DNS setting and port number.
Note: DNS is the domain name server obtained from your ISP (Internet Service Provider).
Note: The default port number is 80. Typically, the TCP port used by HTTP is 80. However in some cases,
it is better to change this port number for added flexibility or security.
Then, note down the IP address shown in "IP". This is the IP address assigned to your NVR by the router.
You'll need it later for port forwarding.
Step4: Go to "DDNS", and select "eagleeyes" in "SYSTEM NAME".
Note down the whole address under "CURRENT HOST ADDRESS", such as
MAC000E5318B3F0@ddns.dvrtw.com.tw. This will be the address used to access your NVR remotely.
CONNECTION
CAMERA
DETECTION
ALERT
NETWORK
DISPLAY
RECORD
NOTIFY
EXIT
Then, select "EXIT" to return to the live view, and continue to Step5 for port forwarding.
Step5: From the web browser of your PC, enter the IP address of your router to access your router.
Note: Enter the user name and password if needed.
Step6: In the router setting interface, go to the port forwarding (or virtual server) rule configuration page.
Note: The naming of port forwarding or virtual server may vary based on different router brands. To
know where it is, please refer to the user manual of your router.
Then, enter the NVR IP address and the port number you note down in Step3, and enable this rule.
Take D-Link router as an example:
Go to "ADVANCED"  "PORT FORWARDING".
(ADVANCED CONFIG), and select "Network"  "WAN".
ADVANCED CONFIG
WAN LAN E-MAIL DDNS
NETWORK TYPE
IP
GATEWAY
NETMASK
PRIMARY DNS
SECONDARY DNS
PORT
ADVANCED CONFIG
WAN LAN E-MAIL DDNS
DDNS
SYSTEM NAME
HOST NAME
E-MAIL
CURRENT HOST ADDRESS
MAC000E5318B3F0.ddns.dvrtw.com.tw
14
DHCP
192.168.1.112
192.168.1.254
255.255.255.0
168.095.1.1
139.175.55.244
88
ON
eagleeyes
MAC000E5318B3F0
EMPTY
NETWORK CONFIGURATIONS