Static / Dhcp Mode - Avtech AVH306 Schnellstart

2.1.2 Static / DHCP Mode

Note: SETTING Path:
When the LAN port of the NVR is connected to a router (not a hub), you can:
 Choose "Static" when you know the network segment of your router.
For example, the IP address of your router of 192.168.0.1, and the network segment of your router will be
192.168.0.xx (xx is ranged from 2 ~ 254).
You can assign the IP address of the connected IP camera(s) by yourself.
 Choose "DHCP" when your router supports the DHCP function, and you do not know the network segment of
your router.
The IP address of the connected IP camera(s) will be assigned by your router.
Note: The rear panel may vary depending on the models, so the above picture is only for reference.
ADVANCED CONFIG)  NETWORK  LAN  MODE.
(
5
CONNECTION