Operating Determinations - EuroLite LED DL-10 Bedienungsanleitung

Please make sure that there are no obvious transport damages. Should you notice any damages on the A/C
connection cable or on the casing, do not take the device into operation and immediately consult your local
dealer.
DANGER TO LIFE!
The electric connection must only be carried out by a qualified electrician!
This device falls under protection-class I. Therefore it is essential that the yellow/green conductor gets
connected to earth.
The installer must always make sure to connect suitable terminals, connectors and cables!
All valid instructions concerning the electric installation be adhered!
Keep away children and amateurs!

OPERATING DETERMINATIONS

This device is a recessed luminaire for fixed installations. This product is only allowed to be operated with
the voltage given on the type-plate.
This product was designed for indoor use only. The device must never be installed in damp rooms.
The ambient temperature must always be between -5° C and +45° C. Keep away from direct insulation
(particularly in cars) and heaters.
The relative humidity must not exceed 50 % with an ambient temperature of 45° C.
This device must only be operated in an altitude between -20 and 2000 m over NN.
The device is only allowed for ceiling or wall installation, but must not be installed in the ground.
This luminaire must never be covered by insulation material, vapour foils or similar building material. Danger
of burning!
Never operate heat-emitting devices (e.g. heating system) next to the installed luminaire. Do not install the
luminaire in the neighbourhood of heat-emitting installations (e.g. heating tubes).
This recessed luminaire must never be installed at furniture.
The F-symbol means: this device can be installed on normal inflammable surfaces.
- - -m
The symbol determines the minimum distance from lighted objects. The minimum distance
between light-output and the illuminated surface must be more than the given value.
Do not shake the device. Avoid brute force when installing or operating the device.
When choosing the installation-spot, please make sure that the device is not exposed to extreme heat,
moisture or dust. There should not be any cables lying around. You endanger your own and the safety of
others!
This device must never be operated or stockpiled in sourroundings where splash water, rain, moisture or fog
may harm the device. Moisture or very high humidity can reduce the insulation and lead to mortal electrical
shocks.
Never use solvents or aggressive detergents in order to clean the device! Rather use a soft and damp cloth.
8/10 00029714.DOC, Version 1.1