Regulating The Air Flow; Setting The Temperature - Herth+Buss 95920000 Handbuch

Operating Instruction
Defrosting iced-over stairs and steps,
door locks, boot lids, car doors or water
EN
pipes. Please ensure that the pipe in
question is actually a water pipe. Water
pipes are often difficult to tell apart from
gas pipes (gas pipes must never be
heated up). Defrosting refrigerators and
freezer cabinets.

5. Regulating the air flow

The air flow can be regulated with the air
flow control button.
Minimum air flow
Maximum air flow
To increase the air flow, press the air flow
control button.
www.herthundbuss.com

6. Setting the temperature

The temperature can only be regulated in
the hot air setting.
0
1
2
To increase the temperature, press "+" on
the temperature control button, to reduce
the temperature, press "–" on the temperature
control button.
7. Cooling air setting
The air flow can be regulated, the temperature
is set to 50 °C (can not be regulated).
0
1
2
The cooling air setting is suitable for cooling
down a heated workpiece or for drying paint.
It is also suitable for cooling down the electric
tool before it is put away or before the noz-
zles are changed. When switching from the
hot air setting with higher temperatures, it
takes a short time for the electric tool to cool
down to 50 °C. During the cool-down phase,
the display shows the actual temperature on
the nozzle outlet. When switching from the
hot air setting to the cooling air setting, the
current settings for the air flow are adopted.
95920000
16