Maintenance; General; Cleaning; Options And Accessories - Hatco DRAWERMAX HDM Serie Installations- Und Bedienungshandbuch

General

DRAWERMAX Drawer Warmers are designed for maximum
durability and performance with minimum maintenance.
WARNING
ELECTRIC SHOCk HAzARD:
• Turn the power switch OFF, unplug the power cord, and
allow the unit to cool before performing any
maintenance or cleaning.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Do not steam clean or use excessive water on the unit.
• This unit is not "jet-proof" construction. Do not use jet-
clean spray to clean this unit.
• Do not clean the unit when it is energized or hot.
This unit has no "user-serviceable" parts. If service is
required on this unit, contact an Authorized Hatco Service
Agent or contact the Hatco Service Department at 414-671-
6350; fax 414-671-3976.
76 mm (3") Casters
76 mm (3") casters are available for the freestanding unit in
place of the legs. Use the following procedure to install casters
onto the bottom of the unit.
NOTICE
Do not lay unit on the front or back side or damage to the
unit could occur.
1. Remove any pans from the drawers of the unit.
2. Carefully lay the unit on its left or right side (requires two
people).
3. Remove the legs, if installed.
4. Place a washer (supplied with casters) over the threaded
stud on the caster.
Form No. HDMCEM-1010

Cleaning

To preserve the finish of the unit as well as maintain
performance, it is recommended that the unit be cleaned daily.
1. Turn off the unit, unplug the power cord (freestanding
models), and allow the unit to cool.
2. Remove and wash all food pans and accessories.
Use non-abrasive cleaners only. Abrasive cleaners could
scratch the finish of the unit, marring its appearance and
making it susceptible to soil accumulation.
3. Wipe down surfaces using a damp cloth. A non-abrasive,
cream cleaner may be used for difficult stains.
• Make sure to check and clean the interior of the unit.
Food pieces may fall from the food pans into the drawer
cavity. CAUTION! Burn Hazard — Do not clean
drawer cavity when unit is on or plugged in!

OPTIONS AND ACCESSORIES

5. Install the caster with washer into a hole where a leg was
removed. Tighten securely.
Figure 12. Installing Casters
6. Repeat steps 3 and 4 for the remaining three casters.
7. Return the unit to the upright position (requires two
people).
9

MAINTENANCE

NOTICE
Washer
76 mm (3") Caster