JCM Technologies MICRO-DCS Bedienungsanleitung Seite 21

DELETION OF MEMORY
Once a code is recorded in the memory of the receiver card, it cannot be
deleted individually. The codes recorded there can only be eliminated by
erasing the entire memory (performing a "system reset"). To erase the
contents of the memory of the receiver, press the programming button for
5 seconds. After the first second the unit will emit a long "beep" that will
indicate that the unit has entered the programming mode (do not pay
attention to this "beep"). After the 5 seconds, the unit will emit a series of
short intermittent "beeps", indicating that the memory is free and that the
receiver is in the programming mode ready for new commands to be
entered. The installation PIN will remain operative.
Deletion of PIN: Keeping pressed the programming button during 5 seconds
more after the reset, the unit will emit a long serie of short intermittent
"beeps" indicating the deletion of the PIN
Note : if the receiver memory were altered by any unusual external
factor, the microreceiver will give off intermittent audible signals
when the channel of a transmitter that has already been stored
is pressed, until the microreceiver power is disconnected.
CODE REPLACEMET
This function enables you to cancel any lost or robbed transmitter,
using the same code and without the necessity of having the
receiver present in order to cancel the lost code. By means of a MANAGER
or MINIMAN portable programmer and knowing the code, you can change
the "Replacement Number", from "0" to "7" (0 is the first remote
control delivered by the factory, and 7 the last "replacement" before setting
the code as obsolete in the installation). The system permits such "replacements"
from a new transmitter, changing the code and "Replacement Number"
(see MANAGER portable programmer manual). Emitting the code to the
receiver, the new replacement number will cancel the previous one and will
be automatically updated.
In the installation, the user must activate the transmitter twice. The first time,
the receiver updates the new element and cancels the previous one. The
second time, the receiver activates the corresponding operation in the
receiver.
USE OF THE MICRORECEIVER
This receiver is designed to operate automatic garage door openers, provide
the movement signals to control boards and connect/disconnect alarms.
No warranty is offered for USE in direct activation of units other than those
specified.
20