JCM Technologies MICRO-DCS Bedienungsanleitung Seite 17

2 by the second channel, if the emitter is programmed using the first channel.
- The relays are activated as follows: Relay 1 by the third channel and
Relay 2 by the fourth channel, if the emitter is programmed using the third
channel.
Channel activation mode:
Pulse-operating:
Select by setting the relay selector microswitches first channel and/or second
channel to OFF.
This is the most commonly used function. The relay remains activated whilst
the transmitter button is pressed.
Bistable:
Select by setting the relay selection microswitches first channel and/or
second channel to ON.
When the transmitter is first pressed, the relay closes and remains in this
position even after the transmitter button is released. Pressing the transmitter
again causes it to open, pressing it a third time causes it to close again and
so on. Used to connect/disconnect alarm systems, etc.
Note: in the single-channel version, the second channel relay selection
microswitch is disabled and set-up is irrelevant.
DESCRIPTION OF THE MOTHER BOARD
Power LED
Antenna connector
Radio card
Memory card
Selector bridge
12/24V
24V
12V
16
Y/N jumper for radio
programming
Programming /
reset button
Channel 1&2
selector microswitch in
pulse /bistable mode
Relay activation
LED's