JCM Technologies MICRO-DCS Bedienungsanleitung Seite 19

There are several different ways to program the microreceiver:
MANUAL PROGRAMMING
Press the programming button for 1 second: the red programming LED will
light up and remain lit during for 1 second. A long "beep" will indicate
that the unit has entered the programming mode. Press the channels of
each command to be recorded in the memory of the receiver. After 10
seconds without programming any command, or on pressing the button on
the rear of any recorded transmitter, the control unit will exit the programming
mode and enter the operation mode, ready to activate the relays.
PROGRAMMING WITH THE PORTABLE PROGRAMMER
Never remove or insert the memory card when the receiver is
in programming mode. Always switch to operating mode or
STOP
disconnect the power to prevent any damage to memory.
•Remove the memory card from the micro-receiver.
• Insert it in the connector provided for this purpose in the portable programmer.
• Perform the steps desired (memorising reserve codes, copies, etc.).
• Re-insert the memory card in the micro-receiver.
PROGRAMMING OF ADDITIONAL TRANSMITTERS VIA RADIO
• In order to be able to work in this mode and place the microreceiver in
programming mode via radio, the transmitter must already be stored in
this microreceiver.
• To allow programming via radio, the activation bridge YES/NO must
have been set in the left position to short circuit the central and left pins.
• With the point of a pen or a paper-clip, press the button in the rear of
the transmitter which is already recorded in this receiver. (If there is more
than one receiver nearby, this will activate the programming mode in all
of them.) A long acoustic signal will sound, indicating that the receiver has
entered the programming mode.
• To record each of the new transmitters, press the corresponding channel
in each of them. A short acoustic signal after each recording will confirm
that the programming has proceeded correctly.
• It should be taken into account that on recording new transmitter by this
method, these can only be recorded with the same channel which recorded
PROGRAMMING
18