Switching On And Off - Garrecht Avionik VT-01 Bedienungsanleitung

Garrecht Avionik GmbH

2. Switching on and off

screenshots shown below will be skipped automatically.
Garrecht
VT-01
SteeringUnit
Softw.v 1.01
Mode-S Addr.
12AB34 hex
Mode-S Addr.
INVALID
running in
A/C mode
FL045
SBY 0022
To switch off the system, press the on/off key and hold it for at least 3 seconds. When holding the key,
the system counts down from 3 seconds to zero. When the screen is blank, release the key.
Revision: 1.2
VT-01 Transponder
Press the On/Off key shortly to switch on the unit.
After the system start, the screens shown below are
displayed.
If the system power is interrupted shortly (less than 10
seconds.), the unit restarts in a quick boot mode and
continues operation within 1 second. In this case the
>0021
7
Start screen showing system name and
manufacturer
Information about Steering unit (=CPNL)
S/N = Serial number
•
HW = Hardware release
•
SW = Firmware release
•
Entered Mode-S Adress (hex format)
Note: If no Mode-S Adress has been entered,
confirm the Messages below by pressing any
key except ON/OFF
This screen will be shown only, if no Mode-S
address has been entered. Confirm it by
pressing any key except ON/OFF.
This screen will be shown only, if no Mode-S
address has been entered. Confirm it by
pressing any key except ON/OFF.
Main screen of the operating system after
performing self tests and showing all the
screens above. When switched on manually
or after power interruption greater than 10
seconds the system is set to the Standby
(SBY) mode always.
User manual
Dokument 01.0200.10E
12.01.2006